Heating & Cooling Experts in Downingtown, PA

Customer is concerned about the heat pump running more often during cold days check operation of the heat pump up upon arrival. Instructed customer turned the thermostat to 74 heat pump came on and also auxiliary was showing on thermostat. Test operation of system 42 amps on back up heat, check refrigerant levels and pressure ok levels are within manufacture specifications. Check supply and return temp ok. Filter is dirty customer will replace filter.

Check up on a heat pump system. Checked the air filter found good . Checked the wiring connections and the voltages. Checked the thermostat in all heating modes, started with electric heat. Inspected the amps for the heating elements and checked the blower amps and the operation. Took electric heat temps at the return and supply. Performed a outdoor BTU output for the heat pump. Checked the outdoor unit, wire connections and the voltages. Checked the outdoor unit pressures . Inspected the components and tested the amps draws for the compressor and the fan motor. The heat pump is in good working order.

Completed heat tune up for 3 Ton Heat pump with 10KW electric heat kit Replaced 20x20x1 filter Indoor and outdoor coils in good condition Cleared EZ trap and checked condensate pump Verified humidifier operations, pad in good condition Inspected wiring and controls, electric heat amps 41 Good. Left estimate for surge protectors Measured temperature rise and static pressure Checked refrigerant charge and pressures Tested defrost System operating well at this time.

Check up on a heat pump system. Checked the air filter found good, customer services both his filters. Checked the wiring connections and the voltages. Checked the thermostat in all heating modes, started with electric heat. Inspected the amps for the heating elements and checked the blower amps and the operation. Took electric heat temps at the return and supply. Performed a outdoor BTU output for the heat pump. Checked the outdoor unit, wire connections and the voltages. Inspected the components and tested the amps draws for the compressor and the fan motor. The heat pump is in good working order.

Completed heat tune up for 80,000 BTU propane furnace: Replaced 16x25x1 filter Inspected burners, heat exchanger, inducer assembly Cleaned flame sensor and verified flame rectification circuit Ignitor in good condition, measured ohm value Confirmed manifold gas pressures Inspected drains, cleared EZ trap added treatment tabs to pump Inspected wiring and controls, left estimate for surge protector for indoor equipment Measured temperature rise and static pressure Combustion and draft tests: Pass System operating well at this time. Noticed that the after heater drain valve had a very slight leak at the stem. I attempted to adjust drain valve and the leak is still at a very slow trickle. I showed homeowner and put a bucket underneath the valve that is catching the water for now. Left estimate to replace water heater drain valve. Also left 2 estimate to replace 50 gallon propane power vented water heater. 1 for Rheem water heater the other for Bradford white water heater.